Hide Table of Contents

Creating Model Break Views in Assemblies

To create model break views in assemblies:

  1. Open install_dir\samples\whatsnew\parts\model break views\flow body.sldasm.
  2. Click Insert > Model Break View.
  3. In the graphics area, use the handles to move the red and green planes approximately as shown.

  4. In the PropertyManager:
    1. Click the Styles tab.
    2. Under Style, click Pipe Break .
    3. For Method, click Individual Breaks .
    4. Under Properties:

      • Set Gap to 100.
      • Move the Shape Intensity control about half way between the center and High.
      • Set Angle to 15º.

    5. Click .

    Although the break is applied, the dimension, 2215, remains the same.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating Model Break Views in Assemblies
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21