Hide Table of Contents

Creating a Variable Pattern

To create a variable pattern:

  1. Open install_dir\samples\whatsnew\parts\bottle.sldprt.



  2. In the FeatureManager design tree, expand Revolve2 , click Sketch2 and click Edit Sketch .
  3. Note that the sketch includes two points that are coincident to the edge of the bottle.
  4. Click Exit Sketch .
  5. Click Insert > Pattern/Mirror > Variable Pattern or click Variable Pattern (Features toolbar).
  6. For Features to Pattern , in the graphics area or the flyout FeatureManager design tree, select Revolve2 and Fillet1 .


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating a Variable Pattern
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21