Hide Table of Contents

Using Dynamic Surface Curvature Combs

Now use the pointer to place curvature values at more specific locations in the model.

  1. Click View > Display > Surface Curvature Combs.
  2. In the PropertyManager, under Options, select Dynamic.
  3. Drag the pointer along the face.

    Curvature values appear.

  4. Click approximately in the areas shown.

    The curvature combs display until you close the PropertyManager.

    You can move the curvature combs by dragging the vertex.

  5. Click .


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Using Dynamic Surface Curvature Combs
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2015 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46