Simulation of Orthodontic Archwire with Nitinol Material Model

In this lesson you analyze an Orthodontic archwire made of Nitinol. The archwire has a rectangular cross section of dimensions 0.635X0.432 mm. The archwire is loaded and unloaded by applying 7 mm prescribed displacements on the end sections.

Due to symmetry of the loads and geometry, you analyze one half of the archwire.

Search 'Simulation of Orthodontic Archwire with Nitinol Material Model' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Simulation of Orthodontic Archwire with Nitinol Material Model
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

Just this topic

This topic and only immediate topics under it (up to 10 topics)

Cancel

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

x

Web Help Content Version: SOLIDWORKS Simulation Tutorials (3DEXPERIENCE SOLIDWORKS) 2025 SP2

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.