Review a configuration of the model where the top of the eyebar is
flatter.
-
Click the Ready-DesignInsight study tab to select the study.
-
In the Simulation study tree, right-click Ready-DesignInsight and select Activate SW Configuration.
-
Right-click the study in the Simulation study tree and select
Run
.
-
After analysis ends, create a P1:
1st Principal Stress plot with psi for units.
The weight of the new design after the removal of material is 10% less than
the original design. The maximum first principal stress for the new design
is ~3.2% higher.
| |
Original Configuration |
New Configuration |
Change |
| Max P1: 1st Principal
Stress |
793 psi |
818.5 psi |
3.21% increase |
| Weight |
.87 lbs |
.79 lbs |
10.1% decrease |
Congratulations! You have completed this lesson.