> Simulation Tutorials for SOLIDWORKS Connected Users > Static Tutorials (SOLIDWORKS Standard and above) > Static Analysis of a Sheet Metal Part

Simulation Tutorials for SOLIDWORKS Connected Users

Static Tutorials (SOLIDWORKS Standard and above)

Static (Stress) Analysis of a Part

Static Analysis of an Assembly

Static Analysis with a Mixed Mesh

Analysis of a Fuel Storage Tank

Contact Analysis of an Eyebar Assembly

Large Displacement Contact

Shrink Fitting of Two Rings

Remote Forces

Static Analysis of a Sheet Metal Part

Converting Solid Geometry to Surfaces

Converting a Thin Solid Body into a Sheet Metal and Surface Body

Failure Analysis of a Composite Joint (Simulation Premium only)

Symmetry Restraints for Solid and Shell Models

Using Adaptive Methods

Analysis of a Pulley Under a Bearing Force

Pliers Defined Using Pins

Analysis of a Basketball Assembly With Bolts

Spot Weld of Automobile Parts

Design Check for Connectors

Design Check for a Mixed Mesh Assembly

Static Analysis of a Truss

Creating Beam Diagrams

Actuator Mechanism with Connectors

Frequency Tutorial (Simulation Professional and above)

Design Insight Tutorials (Simulation Professional and above)

Thermal Tutorials (Simulation Professional and above)

Buckling Tutorial (Simulation Professional and above)

Fatigue Tutorials (Simulation Standard and above)

Nonlinear Tutorials (Simulation Premium only)

Linear Dynamics Tutorials (Simulation Premium only)

Drop Test Tutorials (Simulation Professional and above)

Pressure Vessel Design Tutorial (Simulation Professional and above)

Trend Tracker Tutorial (Simulation Standard and above)

Motion Tutorials (available with SOLIDWORKS Motion)

Simulation Validation for SOLIDWORKS Connected Users

Static Analysis of a Sheet Metal Part

This lesson shows you how to perform static analysis on a sheet metal part.

In this lesson, you learn the following:

Creating a static analysis study
Choosing a solver
Assigning material to the part
Applying a fixed restraint and a pressure load
Viewing stress results on shell models

Search 'Static Analysis of a Sheet Metal Part' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Static Analysis of a Sheet Metal Part
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

Just this topic

This topic and only immediate topics under it (up to 11 topics)

Cancel

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

x

Web Help Content Version: SOLIDWORKS Simulation Tutorials (3DEXPERIENCE SOLIDWORKS) 2025 SP2

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.