Listing Normal Stress at the Interface

You list normal stresses SZ at the upper edge of the interface.

1. Right-click Stress1 (-Z normal-) in the Results folder and select Probe .
2. In the PropertyManager under Options, select On selected entities.
3. Under Results:
   1. Select the upper edge of the interface of the two cantilevers for Faces, Edges, or Vertices .
   2. Click Update.
      
   Under Summary, the average normal stress is listed as 60,002 psi. A positive value indicates tension.
4. Under Results:
   1. Right-click in Faces, Edges, or Vertices and click Clear Selections.
   2. Select the lower edge of the interface of the two cantilevers for Faces, Edges, or Vertices .
   3. Click Update.
      
   Under Summary, the average normal stress is listed as -60,000 psi. A negative value indicates compression.
5. Click .