Completing the Manual Route

Now make the endpoint of the new route coincident with the centerline of the larger pipe and align the pipe with the weldment section in the bottom frame of the main assembly.

1. Select the end point of the newest route.
2. Hold down Ctrl and select the centerline of the larger pipe.
3. In the PropertyManager, under Add Relations, select Coincident .
   The last route segment and all the segments in the same plane move to a plane coincident with the centerline of the larger pipe.

   

4. Click .
5. Click Top (Standard Views toolbar).
6. Drag the route so that the pipe is over the weldment section as shown.
   
7. Click Isometric (Standard Views toolbar).
8. Close the sketch and exit the route.