General Routing
- You can override the automatic creation of stubs when you Alt + drag-drop connectors or fittings in the graphics area.
You can:
- Insert parts without automatically starting a route.
- Mate or position the part before starting a route.
- The Sketcher Triad tool is available in Piping and Flexible Tubing. Previously, it was only available in Electrical routes.
- Multiple instances of the same component are numerically referenced in the Wire From-to List. For example, when a plug is in the top assembly and also in a subassembly, both instances are uniquely referenced in the Wire From-to List.
Piping
You are notified with an error message that points out the junction, if a penetration is missing at the junction of pipes.