Hide Table of Contents

Using Format Painter

In this drawing, you paint the bilateral toleranced dimension format to the other dimension.



To use Format Painter:

  1. Click Format Painter (Tools toolbar) or Tools > Format Painter.
  2. Select the source dimension for the format.

    The dimension changes color.

  3. Select the destination dimensions to paint with the source dimension format.

    The destination dimension changes to a bilateral format and applies the same tolerance values.

    If the destination dimension already has a tolerance, Format Painter applies the bilateral format, but does not override the tolerance values.
    Source with bilateral tolerance values Format Painter paints the bilateral format to the destination but leaves the existing .009 tolerance value intact

  4. Click to close the PropertyManager.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Using Format Painter
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.