Specifying the Wire and Pins

Next, specify the details of the wires running through the harness.

1. Click Edit Wires (Electrical toolbar).
2. In the PropertyManager, click Add Wire .
3. Double-click 20g blue and click OK.

   Selecting 20g blue assigns the 20-gauge blue wire part to the internal cable wire when you complete this procedure.

   20g blue appears in Selected Wires.
4. Click Select Path in the Edit Wires PropertyManager.
5. Select the cable.

   

6. Click .
7. Under From - To Parameters, select 1 for Pin for each plug.
8. Click .

   The harness contains a single 20-gauge blue wire connected to Pin 1 on each plug.

9. Click Exit Sketch and Edit Component .