The names of components listed in the Insert
Component PropertyManager are derived from the imported from-to list. Next,
you insert the listed components and complete the route specified by the from-to
list.
-
Click Rotate
(View
toolbar) and Zoom to Fit
(View toolbar) for access
to the short side of the assembly with six
holes.
-
Insert
battery1
in the
upper-right
hole and motor1 in the lower middle hole
as shown.
When you mate a connector, it is removed from the
Insert route connectors list
in the PropertyManager.
-
Insert xcon1, xcon2, and xcon3 from left to right in the opposite wall of the assembly.
-
Click Yes when prompted
to start the route.
-
Click
to
close the Route Properties
PropertyManager.
The Auto Route
PropertyManager appears.