Sketching the Rest of the Lines

Continue sketching the other lines from the endpoint of the 135mm line. Each time you begin a new line, the origin for the current coordinate system is displayed at the beginning of the new line to help orient you.

Sketch the following lines to an approximate length, then dimension to the exact length later.
  1. Click Line (Sketch toolbar).
  2. Sketch down the Y axis for 15.
  3. Sketch along the X axis for 15.
  4. Press Tab to change the sketch plane to the YZ plane . If the sketch plane does not change, switch to the Trimetric or Isometric standard view and try again.
  5. Sketch along the Z axis for 240.
  6. Press Tab twice to change the sketch plane back to the XY plane.
  7. Sketch back along the X axis for 15.
  8. Sketch up the Y axis for 15.
  9. Sketch back along the X axis for 135.

Your sketch should look like this image: