Inserting Weldment Cut List Tables in Drawings To insert a weldment cut list table into a drawing: In a drawing, click Weldment Cut List (Table toolbar) or Insert > Tables > Weldment Cut List. Select a drawing view. Specify properties in the Weldment Cut List PropertyManager, then click . If you did not select Attach to anchor point in the PropertyManager, click in the graphics area to place the cut list. You can insert multiple cut lists in a drawing sheet. Be sure to trim structural members in the part document so that correct lengths appear on the cut list in the drawing. For example, use Trim/Extend (Weldments toolbar) to trim both ends of the cross member flush with the faces of the side members so the correct length (270) appears on the cut list. Before trimming After trimming Parent topicWeldment Cut List Tables Updating Cut Lists Excluding Features from Cut Lists Sorting Columns in Weldment Cut List Tables Sorting Weldment Cut List Tables By Item Numbers Configurations in Weldment Cut Lists Materials in Weldment Cut Lists Custom Properties in Weldment Cut Lists Weldment Cut List PropertyManager Weldment Cut List Column PropertyManager