Hide Table of Contents

Distributed Mass PropertyManager

Distributes a specified mass value on the selected faces for use with static, frequency, buckling, and linear dynamic studies. Use this functionality to simulate the effect of components that are suppressed or not included in the modeling when their mass can be assumed to be uniformly distributed on the specified faces. The distributed mass is assumed to lie directly on the selected faces, so rotational effects are not considered. Use remote mass if the mass cannot be assumed to be uniformly distributed.

For static studies, you should define either gravity or centrifugal loads in order for the distributed mass to be effective. The program internally calculates the static load based on the acceleration due to gravity defined in the Gravity PropertyManager or angular velocity and angular acceleration parameters defined in the Centrifugal PropertyManager.

Selection

Faces for Distributed Mass Select faces to which you want to apply the remote mass.

Total Mass

Units Sets the unit to be used in specifying the distributed mass.
remotemass.png Distributed Mass Sets the value of the total mass to be applied to the selected face. The total mass is distributed proportionally to the area of each face.

Symbol Settings

  Edit Color Select a color for the distributed mass symbol from the color palette.
Symbol size Use the spin arrows to change the size of the symbols.
  Show preview Turns on/off the display of the distributed mass symbols.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Distributed Mass PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.20