Hide Table of Contents

Bearing Loads

Bearing loads develop between contacting cylindrical faces or edges of shells.

In most cases, the contacting faces or edges have the same radius. The bearing forces generate a nonuniform pressure at the interface of contact. You can select between a sinusoidal variation and a parabolic variation in the appropriate half-space as shown in the figure.

Illustration

The half-space is defined by the space in which the angle Φ is less that or equal to 180º.
brld_top_left.gif brld_top_right.gif
Force will be applied to the lower half of the selected face only Force will be applied only to portion of the selected face located in the half space
brld_botm_left.gif brld_botm_right.gif
No selected area in the half space, no load will be applied Force will be applied to the selected face

brld_caption.gif

Contents



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Bearing Loads
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.20